Point detail

Drawings, in triplicate, in sufficient detail to permit identification of the type of the device and showing the following:

(a) In what geometrical position(s) the device may be mounted on the vehicle; the axis of observation to be taken is the axis of reference in the tests (horizontal angle H = 0°, vertical angle V = 0°); and the point to be taken as the centre of reference in the said tests;

(b) The geometrical conditions of installation of the device(s) that meet(s) the requirements of paragraph 7.;

(c) In the case of an interdependent lamp system, the interdependent lamp or the combination of interdependent lamps that fulfil the requirements of paragraphs 6.7., 7.1. and of Annex 4 to this Regulation;

(d) The position intended for the approval number and the additional symbols in relation to the circle of the approval mark.

Drawings, in triplicate, in sufficient detail to permit identification of the type of device and showing in what geometrical positions(s) the device may be mounted on the vehicle; the axis of observation to be taken as the axis of reference in the tests (horizontal angle H = 0°, vertical angle V = 0°) and the point to be taken as the centre of reference in the said tests; the drawing shall show the position intended for the approval mark and eventually the additional symbols in relation to the circle of the approval mark;