Point detail

Power charging harness
The power charging harness shall be placed in a straight line between the AMN(s) and the vehicle charging plug and shall be routed perpendicularly to the vehicle longitudinal axis (see Figure 3d and Figure 3e). The projected harness length from the side of the AMN(s) to the side of the vehicle shall be 0,8 (+0,2 / -0) m as shown in Figure 3d and Figure 3e.
For a longer harness the extraneous length shall be “Z-folded” in a less than 0,5 m width approximately around the middle of the AMN to vehicle distance. If it is impractical to do so because of harness bulk or stiffness, or because the testing is being done at a user’s installation, the disposition of the excess harness shall be precisely noted in the test report.
The charging harness at the vehicle side shall hang vertically at a distance of 100 (+200 /  0) mm from the vehicle body.
The whole harness shall be placed on a non-conductive, low relative permittivity (dielectric-constant) material (er ≤ 1,4), at (100 ± 25) mm above the ground plane (ALSE) or floor (OTS).